DIN-53516 DIN Abrader Rubber DIN Abrasion Tester Flexible Material
Application
DIN Abrasion Tester is designed to conform to the ASTM, EN, IS0 and DIN standards. This top quality and highly popular abrasion tester will allow you to measure the abrasion resistance of rubbers (vulcanized thermo set rubbers and thermoplastic elastomers) that are subject to abrasive/frictional wear on their actual service. Since wear is always a result of abrasion, different test methods have been developed for the simulation of long-term wear.
Standards
DIN-53516,ISO/DIS-4649,GB-9867
Principle
Under a predetermined contact pressure and a given area,the specimen with sandpaper angled to measure abrasion resistance of the specimen subjected to rubbing on a certain level of sandpaper, sandpaper affixed to the surface of the drum, samples pressed on a drum with sandpaper, and the specimen along the roller to the lateral movement, abrasion resistance is produced at one end of the cylindrical specimen, tests the value of the mass loss of the specimen, by the density of the specimen to calculate the amount of volume abrasion.
Specifications
Roller diameter:φ150mm
Roller length:460mm
Rotate speed:40rpm
Abrasion stroke:40mm(20mm)
Abrasion speed:0.32m/sec
Dip angle:3°
Specimen diameter:φ16 mm
Thickness:6~15 mm
Testing load:5N,10N
Clamp horizontal displacement:4.2mm/roll each lap
Standard accessories:one set of sampler,two pieces of abrasive
paper(VSM60#,41*47.6CM),three pieces of standard gel(φ16*8mm),one piece of power cord.
Guangdong Hongtuo Instrument Technology Co.,Ltd has been specializing in density testing field on developing, innovating and producing since the year it was establised.